Medical tent inflating instructions
May 06, 2020
Step A: Preparation
A1. Spread the floor, and spread the air tube on the floor.
Align the four corner marks, then paste the inflatable roof and floor with the Velcro.
B1. Insert the blower into the air conditioning hole and turn on the blower to start inflating.
B2. When the tent is filled 60% air, workers need enter the tent & turn on the air pump to inflate the air tube.
Workers are required to assist in propping up the inflatable tube during inflation.
When the air tube is inflated to 70%-80%, turn off the air pump, adjust the tube and tarpaulin roof to the best fit by pulling the tube to avoid tube twisting.
B3. Turn off the blower, pull the air tube D-ring out through the small hole on the outside of the inflatable roof.
After all adjustments, turn on the air pump and inflating the air tube again, when the air pressure reached 2.0 PSI, turn off the air pump, then the tent can be used normally.
1. Door: Pull the zippers on both sides, roll up the curtains and fix them with ropes.
2. The window consists of three parts: clear PVC (windproof & light transmissive), net (anti-mosquito), PVC tarpaulin curtain (shading).
Roll up the curtains from the outside and fix to the Velcro lines on both sides.
3. Air conditioning hole: The air conditioner can be installed after rolling up the cover from the outside and fixing it on the Velcro lines.
4. The plastic hooks are placed on the air tube to hang the rope and install the wire and the light strip.
2. Dry the tent, especially the inside roof lining of the tent can't be wet, make sure it is absolutely dry before pack & store it.
3. Storage location requirements: cool and dry.
A1. Spread the floor, and spread the air tube on the floor.
Align the four corner marks, then paste the inflatable roof and floor with the Velcro.
A2. Close the air conditioning hole and the window cover, zip up the door curtain, and spread the tent according to the tent shape.
B1. Insert the blower into the air conditioning hole and turn on the blower to start inflating.B2. When the tent is filled 60% air, workers need enter the tent & turn on the air pump to inflate the air tube.
Workers are required to assist in propping up the inflatable tube during inflation.
When the air tube is inflated to 70%-80%, turn off the air pump, adjust the tube and tarpaulin roof to the best fit by pulling the tube to avoid tube twisting.
B3. Turn off the blower, pull the air tube D-ring out through the small hole on the outside of the inflatable roof.
After all adjustments, turn on the air pump and inflating the air tube again, when the air pressure reached 2.0 PSI, turn off the air pump, then the tent can be used normally.
Other Detail
1. Door: Pull the zippers on both sides, roll up the curtains and fix them with ropes.
2. The window consists of three parts: clear PVC (windproof & light transmissive), net (anti-mosquito), PVC tarpaulin curtain (shading).
Roll up the curtains from the outside and fix to the Velcro lines on both sides.
3. Air conditioning hole: The air conditioner can be installed after rolling up the cover from the outside and fixing it on the Velcro lines.
4. The plastic hooks are placed on the air tube to hang the rope and install the wire and the light strip.
Storage
1. After using the inflatable tent, clean the tent.2. Dry the tent, especially the inside roof lining of the tent can't be wet, make sure it is absolutely dry before pack & store it.
3. Storage location requirements: cool and dry.
ATTENTION! If the inflatable tent is stored without drying, it will be mildewed and rotted.